Español 
Colors in Cosmetic Tubes
The effect of injection mold parts or behavior
by：Lisson
2020-11-20
1.
Mold base: fixed cavity, accurate to adjust its position relative to the nozzle.
2. Guide bar: make the two and a half mold alignment of the injection mould.
3. Material: plastic melt from the sprue into the mold cavity.
4. Female die and male die: control the size, shape and surface texture of molding products.
5. Cooling water channel: control mold surface temperature, in order to make plastic cooling for solid state.
6. Vent: make the gas and air escape from the mouth.
7. Ejection mechanism: from the cavity die or male mold ejection in the curing of molding products.
8. Ejector return pin: when the mold closed during the next cycle, plunger, return to its original position
2. Guide bar: make the two and a half mold alignment of the injection mould.
3. Material: plastic melt from the sprue into the mold cavity.
4. Female die and male die: control the size, shape and surface texture of molding products.
5. Cooling water channel: control mold surface temperature, in order to make plastic cooling for solid state.
6. Vent: make the gas and air escape from the mouth.
7. Ejection mechanism: from the cavity die or male mold ejection in the curing of molding products.
8. Ejector return pin: when the mold closed during the next cycle, plunger, return to its original position
Custom message
Related Products
