Plastic cosmetics packaging production automatic assembly machine is introduced

one Equipment of this equipment for automatic cover assembly equipment for the production of cosmetics packaging, can automatically complete cosmetics packaging production cover parts of automatic assembly. The whole system including the workbench, vibration hopper, had settled on a die, manipulator, pressing up and down, eight cylinder rotary worktable, work positioning mould, discharge chute, electric control cabinet and pneumatic control panel.
2. Equipment working rhythm and adjust the working vibration hopper each discharging three at the same time, the manipulator also grab three artifacts, the whole machine working tempo for 120 PCS/min. Each robot is equipped with one-way throttle valve, adjustable one-way throttle valve to regulate manipulator movement speed, thereby adjusting the whole machine work rhythm. 3. Instructions for each open source before start working, power source, gas source switch on the pneumatic control board, the power switch on the electric control cabinet. The device working pressure for the 7 bar, working voltage is 220 v. Pneumatic control panel and electric control cabinet the components have been debug Settings without having to adjust. In the automatic state, press 'start' button, after the work light is lit, vibration hopper began to work, the material automatically feed to the loading position, manipulator began to pick up the material and placed in the mold of rotating worktable automatically. Pneumatic rotary table for eight location indexing table, each station has a positioning mould, each mold to three workpieces at the same time, the superposition of cosmetics packaging production cover components in turn for each station, stamping, assembly, and finally by the manipulator grasping artifacts placed in blanking slide down the chute. This equipment is under had settled on a mould and work positioning mould are equipped with photoelectric sensor. In the process of equipment operation, if the system detects the assumed that lack of material in a mold, then the system to stop working and buzzer alarm. At this time should be to add enough artifacts, vibration hopper after confirm had settled on a mold for the workpiece, press the 'start' button, once again and system will continue to run normally; If there are residual artifacts work location in the mould, then the system will stop working and beep alarm. At this time should be manually remove residual artifacts, confirm the location without artifacts and then press a 'start' button, system will continue to run normally. In the process of running if press 'pause' button, the system does not immediately stop working. In sequence for each station gradually stop working until rotating worktable without artifacts is to. Working indicator light will flash on the process instructions in the process of the system is in a down, until the system officially stop when the light is put out. In the process of running if you press the 'emergency stop' button, the system immediately stop working, and all robots are in position to stop the current work. Wait to pull up the 'emergency stop' button, the system begins to reset, all mechanical reply to the initial position, waiting for the restart. In the state of system manually each time you press the 'start' button to turn a rotary worktable location in order to remove the mold for each station of the workpiece. In the state of system manual press the 'emergency stop' button, the four vibration hopper is starting to manually adjust the vibration hopper. Note: after the system stops working, all of the manipulator in the initial position, at this point do not pull manipulator at random, in order to prevent the next time when work start air cylinder impact location to malfunction.