Cosmetic plastic bottle mould design steps

1, for the design of mould product feasibility analysis, computer case, for example, using design software components of the product drawings for assembling analysis, namely we say work plans, to ensure the correctness of each product before the mold design drawings, on the other hand can be familiar with the importance of components in the whole case, to determine the key size, so good in the mold design, the specific method of floor here don't do is introduced in detail. 2, must carry on the work after the product analysis, analyze the product adopt what kind of cosmetic plastic bottle mould structure, and the product process, determine the work content, each process and using design software for product development, generally from the following project forward when products, such as a product requirements five process, while the stamping done when products from product drawings to four project, three projects, two projects, a project, and after a graphic before a copy and then to the work of a project, the completed five engineering products, and then a detailed work, note that this step is very important, should be particularly careful at the same time, this step is done well, will save a lot of time in map mould, was determined by the content of stamping of each project, including in the forming die, product material thickness outside threats, to determine the size of intensive use, method for product launch is no longer here, will be introduced in the product expansion method.