Cosmetics packaging production machine daily cosmetics packaging production problem solution

1, the feed themselves feed table: this kind of circumstance is a headache problem, empirically if cosmetics packaging production base ( Embryo) The length of the longer cut weight is bigger, then this kind of phenomenon is relatively less. 2, charging not charging: need to check several ways: 1) , whether to have no material hopper, if is: need to feed 2) If not, please check whether the elevator control contactor in the state of electricity. If it is to state, hurry up to check if motor in electric and load state, because this kind of situation is likely to be (by cosmetics packaging production base Embryo) Stuck belt, then the simplest method is to promote human help. 3) , if the elevator control contactor is not to state, please check whether the embryo to detect magic eye cosmetics packaging production and baffle plate is not on the same line. 3, cosmetics packaging production is a task of the position of the manipulator is misplaced. After 4, cosmetics packaging production into cannot be removed from the mold. Should open the mould first, with a manual process, if the normal, with empty running state run it, if is normal. Please check your exhaust time Settings, if the exhaust set to normal, and every time as long as a cosmetics packaging production failure, then can judge is the problem of exhaust valve, please open the exhaust valve check its spring and seal ( This obstacle so still have a kind of phenomenon is the exhaust noise is larger or have not the voice of the net) 。 If you meet a lot of mold production normal chance to check on the open mold, please check the lock pin if there is a section of the screw inside, please check whether the clamping force is too big, if too large should be in accordance with the standards to adjust. 5, the collision of two mechanical hand need to manually reset manipulator, is caused by misalignment