Macroscopic observation glass bottle whether bright and clean, there are four kinds of surface treatment of poor performance

Visualizing the bottle whether bright and clean, the surface is poor treatment often embodied in:

1, the surface of the fuzzy: general is due to the mould aging, or no change in time during production spare mould, cleaning putty, etc.

2, convex Angle: lobe usually appear in the bottle on the bottom of the bottle, bottle combining ridge and bottle upside, is due to the damage caused by mold production process, generally slightly convex Angle, and the bottle or bottle does not affect the use, convex Angle but if appear in the mouth, that requires attention, need to take the cap test, check whether to form a complete set of seal. Mouth lobe, tend to lead to the lid tight, sealing is not tight.

3, bubble phenomenon and: improper control of glass furnace temperature will produce bubbles, generally does not affect the use, but can lead to a product image to plummet.

4, bottle broom tattoos: at present the bottle broom lines for many manufacturers of headache, broom lines is the bottle slightly a few fine lines, side by side like a broom sweep road surface traces, though not too obvious, but for the pursuit of the perfect glass bottle factory, at present it is hard to solve the problem. For the solution, temporary retention, solve the broom print is at present is to do the secret weapon of glass enterprises.