A series of adjustment methods of labeling machine parts accessories

A series of adjustment methods of labeling machine parts accessories a series of adjustment methods of labeling machine parts accessories

the emergence of the fully automatic labeling machine driving the development of relevant industries vigorously, personalized and automation technology are undoubtedly reveal the charm of the labeling machine. On the market at present the machine product variety is also more and more, the choice of the user, the more the product is also more picky. Good product is inseparable from the user's love, the following is some of labeling machine maintenance items.

pressure adjustment

tag is brushed brush device center for labels and balanced on both sides, and perpendicular to the surface of the container. Pressure brush sweeping container for overlap: a single pressure brush to 10 mm to 15 mm, brush combination pressure for 5 mm to 10 mm. The location of the sponge cleaning brush distance is 1 mm ~ 2 mm. Pressure bottle without the bottle should be 20 mm lower than with the bottle.

tag

the regulation of box center line of the box, the center shaft and label paper and tangent, three points in a line, the plate center shaft to the plate and label paper tangent ( Zero distance) And then move the box near 1 mm ~ 2 mm. On both sides of the paper in the box and layering of the clearance should be 0. 8mm- Between 1 mm, clearance is too large to cause the paper in the box shift, appear inclined standard; The gap is too small will cause push the poorly.

the box to grasp the regulation of the hook position: up and down, left and right sides of the hook in the same vertical plane and even demanding in the paper, can grasp the smoothly.

tag supply roller to adjust: when there is no label, tag clamp to pressure box of the front and a label, tag near the hook refers to cannot be crushed.

bottle into the star wheel, a bottle of star wheel, bottle feeding screw adjustment

in the in and out to adjust the bottle of star wheel and screw into the bottle, the pressure bottle labeling machine shall prevail.

into the bottle of star wheel adjustment: when the pressure bottle head just over the bottle, adjust into the bottle of star wheel, make the bottle in the middle of star wheel groove.

the adjustment of the screw into the bottle, the bottle feeding star wheel shall prevail, and when the bottle in the bottle of star wheel groove right in the middle, the adjusting screw, the screw into the bottle of lateral displacement generated by tight bottles but not.

the bottle of star wheel adjustment: when the pressure bottle just raise head, adjust the star wheel to make the bottle in the middle of star wheel groove.

the station adjustment

adjustment of scraping rubber sheet and rubber roller, scraping rubber sheet and rubber roller cannot appear over the whole length of clearance, if there is a gap can by adjusting the eccentric bolt to adjust the scraping rubber sheet.

rubber roller and the regulation of the board: the plate and rubber roller between just touch each other without any pressure. Gap is too big, too much glue on the board, cause to jilt glue; Gap is too small, contact too tight, the glue will be crowded go, half the board without glue. Practice has proved that the gaps between the roller and at zero. 1毫米~ 0。 Between 2 mm is the best, to be implemented by adjusting the lower roller bearing seat, and, when necessary, to the upper part of the rubber roller bearing. Conversion table packaging printing knowledge