Cosmetic plastic hose manufacturer wine hose spraying method

Cosmetics manufacturers of plastic hose wine hose spraying method

product display cosmetics plastic hose production enterprise wine hose spraying method

cosmetic plastic hose spraying production line generally consists of spray chamber, chain hoist and oven. Cosmetic plastic hose is our country traditional beverage packaging containers, cosmetic plastic is also a kind of has a history of packaging materials. In many kinds of packing materials under the condition of flood the market, cosmetic plastic containers still occupies an important position in the beverage packaging, and other packaging materials can not replace it with this packing characteristics inseparable. Cosmetic plastic hose manufacturer has the advantages of resistance to heat, pressure and cleaning as well as high temperature sterilization, low temperature storage. Because it has many advantages, so the beer, fruit tea, wild jujube juice and many other drinks become the preferred packaging materials.

cosmetics plastic hose factory plastic packaging container's main features are: non-toxic, tasteless; Transparent, beautiful, good barrier property, airtight, abundant raw materials, low prices, and can be repeated use. Cosmetic plastic hose is also positive water treatment, cosmetic plastic hose need to pay special attention to the wastewater discharge. Cosmetic plastic hose spraying quality and water treatment, surface cleaning, hook conductivity, gas, powder content and the level of operating personnel.

we suggest the following methods to try

1, before the treatment period. Cosmetic plastic hose spraying pretreatment period of wine such as preliminary, primary, watch, if it is in the north, the temperature of the Lord to take off the part is not too low, need to heat preservation. Otherwise the treatment effect is not ideal;

　　2. Preheating section. After pretreatment, must enter the preheating section, general need to 8 minutes. When cosmetic plastic hose arrived in powder spraying room, had better make the spraying workpiece produces a certain amount of waste heat, in order to improve the adhesion of powder.

3, cosmetic plastic hose blowing wine purification section. If you want to spraying the workpiece process requirement is higher, then the part is essential. Otherwise, if the workpiece on the adsorption of dust, there will be a lot of processed workpiece surface particles, reducing quality.

　　4。 Powder coating parts. This section is the focus of the powder coating host technical problems. If you want to create a good quality, it is worth to pay for a skilled master.

5, dry period. This section should pay attention to temperature and baking time, powder is 180 degrees, 200 degrees of above commonly, depends on the material of workpiece. And also should not be too far away from spray chamber drying furnace, general 6 m is good.